Marine Paint 4 Litre

 

Warehouse pick up only 

Now available on The Central Coast of NSW Marine Paint 1 litre and 4-litre cans

Boating, Jet Ski's, Fibreglass Slides DIY easy to use Roll, Spray or Brush on, no harder needed, just use as it is.

 

1 PAC POLYEURATHANE 4LT AUSTRALIAN MADE by Crystal Marine Paints It is quick-drying polyurethane that can be brushed rolled or sprayed onto the exterior and interior surfaces.

May be painted onto most solid surfaces, remove all loose particles, dust and oils and sand off to a solid surface.

As most boats have already been painted previously, we strongly recommend that you try a test patch first with the Marine Paint to check that your preparation is correct for the surface. If you don't know what has been applied before and it is best to check first.

Marine Paint Applications

Timber - Bare timber should be sealed with the appropriate primer. Fibreglass - Should be sanded back to a solid surface and can be painted without a primer again, please try a small test patch first. Steel - Bare should be primed with Crystal Marine Red & Grey Phosphate Primer.

Aluminium - May be painted after sanding. Use an etch primer on bare new aluminium. Coverage is approximately 9 -12 square metres per litre depending on the application.

Fibreglass - Should be sanded back to a solid surface and can be painted without a primer again, please try a small test patch first.

Steel - Bare should be primed with Crystal Marine Red & Grey Phosphate Primer. Aluminium - May be painted after sanding. Use an etch primer on bare aluminium.

Marine paint can be easily sanded and we recommend a fine sanding between coats. « For thinning and cleaning up use only mineral turps.

Recoat time 2 - 4 hours depending on weather conditions.

Spraying - only use clean mineral turps for thinning down and only use enough to get the marine paint to go through the spray gun.

Do not paint if the temperature is less than 12çc

Pick up only - The Central Coast NSW - Boating Mooring Stainless Steel supplies